1)You will need tigertail, cutters, flat nose pliers, four crimp beads and a clasp with two completely closed (no gaps) jump rings or loops attached. (Do not use this method with an open jumpring the tigertail will slip out)
2)Cut a length of tigertail (9 inches or 30cm to be safe) thread on two crimp beads, followed by the clasp
3)Loop the tiger tail through the clasp’s jumpring and back through the crimps to form a loop
4) pull the end with pliers until the crimps are next to the clasp (leave some room so the clasp hangs nicely)
5/6) Crush the crimps firmly with the flat nose pliers
7/8) Thread on your beads of choice over both strands of tigertail
9)Finish following steps 2-5 and pull the end of the tigertail back through the last bead
10/11) Snip the end of the tigertail close to the beads to finish